Set up your branded NEO in a few guided steps: choose the capacity, a custom housing color or gradient and your mouthpiece, put your graphic on the LED screen, place your artwork inside the printable areas, and submit.
NEO is one slim housing in two capacities, with a food-grade PCTG tank, an oil window on both faces and an LED display. Choose the capacity, then your housing color (a custom color or a gradient) and your mouthpiece.
Both capacities share the same housing and dimensions.
Enter the official Pantone reference, not a color code.
On-screen color is approximate. Your confirmed Pantone reference will be used for production.
Subject to factory approval. Gradients are reviewed with the factory: your two colors and the blend are confirmed before anything is quoted.
The gradient runs from the top of the device to the base. Color codes are on-screen references, not Pantone matches; PROXY confirms production colors with the factory.
Enter the official Pantone reference, not a color code.
The translucent mouthpiece is tinted by the selected mouthpiece color.
Choose a custom housing color or gradient to continue.
Screen display: when NEO is activated, the logo appears, followed by alternating battery level and puff count. During charging, it shows battery level only.
Custom logo: the factory graphic is standard, and you can replace it with your own logo. The battery and puff count readout below it always stays. This is a digital display setting, separate from the printing on the housing: housing artwork follows in the next step, and the printing method is chosen under Finish & Printing.
Upload your graphic, or choose the Factory Screen Graphic, to continue.
Drag your graphic on the preview to position it; it snaps to the centre lines and stays inside the Screen Graphic Area. It can never overlap the factory readout below.
The readout area is controlled by the factory and is not customizable.
Each surface is set up independently; your original files are always submitted untouched.
You are setting up the front surface. Use the buttons above to switch.
This surface will be submitted as intentionally undecorated: no artwork is required here.
Colors detected in the artwork you uploaded above.
Have official brand colors? Add the Pantone reference so the factory can match them precisely. This does not change your uploaded artwork.
Use the Front / Back toggle above the preview to work on each surface. Drag the artwork on the device and keep it inside the marked Printable Area.
No artwork on this surface yet. Go to step 2 · Artwork and upload a file for this surface, or switch back to the other surface.
Choose based on your artwork. Logos and graphics require a minimum 6 × 6 mm size; text-only artwork can be as small as 1 × 1 mm.
Choose how your NEO should be printed. Decoration methods are confirmed with the factory for NEO before production.
Select a printing method to continue.
Selecting No Printing will remove the artwork currently added to this configuration.
Check your configuration. Submitting sends PROXY a factory-ready branding specification for this build.